A Note on Water Mold Fire Restoration of Minneapolis

Who is exactly the inspector doing during a mold inspection? The first task after the initial visual tests is usually to gage the levels of moisture present in the property’s walls. The moisture levels are assessed at intervals of approximately two feet, and the inspector will pay particular attention in areas under sinks, around water heaters, anywhere there is a water source present. The levels of moisture are measured using a special meter which has two small pins inserted into the lower part of the wall which will provide a reading to indicate the level of moisture. The appropriate standard is at or below 15 per cent. If you are looking for more tips, check out Water Mold Fire Restoration of Minneapolis – Minneapolis water damage restoration.

If your inspector detects wall moisture readings that are greater than the appropriate amount at this point in the mold inspection, or finds signs of water damage or mold growth, he / she will bring them to your attention and probably discuss whether samples should be taken. But, even though there are obvious stains caused by water damage or maybe mold growth the inspector would still be unable to give any indication for certain that you have a mold problem which is why sampling is important.

Most certainly, the sample taken is an air sample. It is possible to determine what strain of mold is present in the atmosphere and in what quantities by taking air samples during a mold inspection. At this level, I must point out that the mold inspector will take at least two samples of the air. The first should be from the troubling field and the second should be from outside. To take an outside sample? The response to that is clear. Mold is found everywhere, we breathe it all the time, and for the most part it’s 100% healthy and it doesn’t affect us anyway. Therefore, it must be determined during a mold inspection whether or not the inside mold is the same strain as the outside strain, and whether it is in the same ratio or less. Clearly, the other side of the coin is that the amount of mold may be the same but the internal concentrations may be much higher, or it may be toxic mold.

Where visible mold growth samples of this can also be taken allowing for the detection of the particular form of mold spores, but this does not decide whether or not such mold spores are in the air.